Cable disc brakes. I kept putting it off but it was riding like shit and didn’t feel safe, brake levers nearly contacting the handlebar. I had it in my head that the adjustment was like a 30 minute job. Grabbed Allen wrenches, a couple third hands, screwdrivers. 5 minutes and two Allen bolts later, all done. Topped off the tires with air, quick test ride, meat’s back on the menu. No real point to this post, but maybe you’ve made a quick adjustment or repair that made you happy?

  • DominusOfMegadeus@sh.itjust.works
    link
    fedilink
    arrow-up
    1
    ·
    3 months ago

    This whole thread is encouraging. I have acquired a used bicycle in a game of chance and I have been procrastinating on the rehab because I was anticipating it becoming some months long project.

    • captainlezbian@lemmy.world
      link
      fedilink
      arrow-up
      1
      ·
      3 months ago

      It can be a months long project or it can be a days long project. But it’s a worthwhile project and the best way to make it quicker is to start it sooner

  • Havald@lemmy.world
    link
    fedilink
    arrow-up
    1
    ·
    3 months ago

    Nice. I’m glad you feel confident enough to run over raccoons for your dinner again.

  • MentalEdge@sopuli.xyz
    link
    fedilink
    English
    arrow-up
    0
    ·
    edit-2
    3 months ago

    I’m assuming there was still material on the pads?

    When the travel starts to bottom out on my hydraulic disk brakes, that typically means it’s time for new brake pads.

    I know that might not be the case with wire brakes because they don’t adjust the caliper piston positions as the pad wears down, but just making sure.

    If the pads no longer have material, simply tightening the brakes can eventually end up ruining the calipers.

    As for the post, I enjoy the same adjustment. That ride with new pads and reset pistons always feels super nice. They perform in such a satisfying manner compared to when they’re almost worn out.

    • Hanrahan@slrpnk.net
      link
      fedilink
      English
      arrow-up
      1
      ·
      8 days ago

      When the travel starts to bottom out on my hydraulic disk brakes, that typically means it’s time for new brake pads.

      Just replaced the brake pads (front an back) on my parters MTB (hydraulic) after we’d finished (she did most of tje work while i mansplained ) I told her to test ride and be careful jamming the brakes on as you’ll notice a difference. She came back “jesus fcukibg christ they nearly sent me over the bar!”. She’d been used to pulling them on further as the pads were well worn.