• 1 Post
  • 19 Comments
Joined 1 year ago
cake
Cake day: June 4th, 2023

help-circle

  • I have a sony as well, and you can use it as dumb TV, by not agreeing to their privacy policy. If you want to connect it to wifi afterwards, it points you to the privacy policy again, so it seems like the TV follows that. But I’ve also purchased it 4 years ago, so not sure what the status is now.

    So far, I’ve seen no ads. I mostly use it mostly via HDMI and sometimes for watching freely available TV via antenna.


  • In retrospect, I should have saved it, but it was my second beer ever and went for an overly complex recipe also. Knowing what I know now, it would have probably aged nicely.

    I’ve discovered boiling is not fully necessary to get a good brew and that heather tips make it awesome. I’ve just added maybe 1-2 handfuls now to the mash. Next autumn I plan to go nuts on collecting the thing and will try to fit maybe half a kilo in there, see how it comes out.

    Honorable mention to red yeast rice, I have this notion of doing a rice mash for maybe a week with it and then plopping that into a raw ale mash to get enzymes and flavour of red yeast rice wine in a beer, as I’ve noticed that its enzymes also work up to 70ish Celsius.










  • Why are you heating your strike water to 71C? is it enough when adding room temp grain to cool down to your target mash (I wonder if you’re not accidentally destroying some enzymes)? What about the age of the grain? Enzymatic activity drops the longer grain is stored. Maybe you got a very old batch?

    Using and AIO system, it should have the ability to control temp during the mash. I use one myself and a general all rounder mash program would be this: add the grain at around 45-54 C, then let it ramp up to 63. Hold for about an hour, ramp to 72, hold 10-30 minutes and then mash out at 78. Sparge at 78. I’d rather start too cold than too hot. Plus, there’s some other enzymes in there that work at low temps but get denatured at 63+ (like proteases and beta-glucanases).



  • Condensation shouldn’t be an issue as long as you’re not cooling below the current dew point.

    However, after experiencing one of these underfloor cooling systems once, I can say that the biggest issue is that cold air tends to be heavier and thus stay down. So in order to cool the entire room, not just the layer of air right above the floor, you need something to move the air, which is probably why they’re providing fans. Either that or you can just lie on the floor all the time…

    Floor heating works because warm air rises. I never understood why ‘floor’ cooling wasn’t piped through the ceiling, instead. There are probably some engineering or heat transfer issues there, though.