Rocket.chat could be an option
Got a split keyboard (ergodox ez) just to notice that all the special keys are very tough to reach and there are no F-keys. All in all not such a great experience. The split part is good though if you type a loooot anf if you have wrist rests.
Did you measure that? Would be great if it was only fractions of a mm.
Would a larger inner diameter not cause the transmission of movement to be less direct due to bending and coiling inside the tube? This is probably mostly an issue in bowden systems
Damn, now I need to try it out just to be sure.
Hey, I wanted to read that!!
How do you get these dirty pixely lines?
I read that poppie seeds regularly contain too much opioid and have to be pulled from sales. Hemp rope on the other hand is made from the stem of the plant, not the flower, so does not or barely contains THC.
What about some rollo blinds? We have them shut during daytime in summer in the rooms we don’t use all the time. They also help sleep in the dark if that’s your thing. The drawback is that they often create a weak spot wrt. Insulation.
I learnt to only leave on growth bud. Give it a try on your next grow! It’s supposed to both make the plant more manageable and productive.
Did you try eating the seeds? I’ve heard that (in germany) they regularly need to remove poppy seeds from stores because the harvest had too much of the psychoactive ingredient. Also apparently people used the seeds in cake knowing they had a mild pleasurable effect.
Do you remove the suckers? If done diligently the plants tend to only grow in length and stay more manageable. Nice plant in any way!
Also, what variety is it?
Sorry, I completely didn’t read all of your comment. You’re right about resistance but then again the filament won’t need to touch the enclosing coil at a large surface. In the usual bowden tubes, you have a lot of contact surface between tube and filament but this would not need to be the case in the drying coil. In the end it would all depend on the application. I’m not interested in very high speed printing (yet) because my machines are all pretty slow :).
You “just” need a longer distance inside the drying chamber. This could be achieved by coiling up the space where the filament travels through and guide hot and dry air through that space, ideally from the outlet towards the inlet. That air could maybe be pulled from the hotend cooler.
Argh finally someone tries the obvious solution. I was already considering it but was demotivated since it seemed so obvious and nobody seemed to have done it before.
This device could also probably be printed in PLA. I can’t wait until I get my lab power supply so I can give this a try with a wire coil heater.
Edit: you could even mount some PTFE tubing mounted below a heated bed and pass air through it. That way you could potentially get away without a heating element and re-use some power usually lost.
This! The breeder basically keeps two parental lines that they use to make the seeds. Usually they need to do the crossing pollination by hand somehow and make sure that no foreign pollen fertilize the females. There is a great and accessible book about breeding by Carol Deppe if you’re interested in breeding plants in generally https://www.chelseagreen.com/product/breed-your-own-vegetable-varieties/
I’ve also always been wondering about this and other questions before reading that book.
Not only this. It’s also old news.
Full agree!! I use the dev version too!
The 1.0 release is around the corner. It’s only a matter of a few weeks. It has the toponaming problem fixed and a built in assembly toolbox!
What should notifications be like instead?