PS5 Pro is going for 800 EUR so I’ve picked these parts: https://pcpartpicker.com/list/BnpTsh, and it’s almost spot on how much it costs after converting it into USD. (800 EUR = 881.83 USD)

PEI is one of the best surfaces you will ever find to print on, although I believe one type of filament (I think a variation of PLA?) sticks too well and can damage the PEI trying to take prints off…

That’s PETG. I avoid using smooth PEI plates like fire when PETG is loaded. Even after swapping the filament to PLA, little bits of residual PETG can still stick leaving a shadow on the plate. Textured PEI is mostly fine, but single layer stuff like brims are a pain to get off.

From what I understand it tests the minimum retraction distance you need to avoid stringing. The lower you get the less retraction you need. For example, for me usually it stops stringing around 0.4mm retraction (that’s 4mm measured from the hot plate), but found that in real conditions the default 0.6mm works better. I don’t find this test too useful, for me it fails to demonstrate the spectrum between too little and too much retraction, a feature I appreciate in the pressure advance tower. Apparently the moment it stops stringing, anything after that won’t show you anything new and it’s best to stop the print. Either that or I fail to notice any defects when the retraction is relatively high.

There’s a request made here. Haven’t seen devs reply yet though.

I’m thinking about getting some of those activated alumina beads. I’ve heard they are both more efficient at absorbing moisture and can be recycled indefinitely without degrading. Sounds like a perfect fit for your setup.

Dry and then store in a controlled environment. I’m using those bog standard cereal containers from Amazon (3,7-4l container should do for 1kg spools). Add some desiccant, spool rollers and a hygrometer and you have yourself a semi-permanent home for your spools. Mine show somewhere between 10% and 15% humidity, so that’s pretty good considering that previously just leaving a spool in open air for a single longer print caused it to soak enough moisture to ooze and string by the end of the print, and that’s in “only” over 40% humidity. So yeah, highly recommended.

Yep. While mods them self don’t cost nothing, in general I’d say (compared to what a cigarette smoker would spend) this activity is relatively cheap. Biggest cost for me is flavoring and nicotine. The rest is negligible.

As a vaper I support this notion. Disposable vapes should go. Pods with replaceable cartridges and preferably also replaceable batteries (yes, those exist) should take their place. I’m mostly a RBA guy, so my only waste is a bit of cotton, some glycol/glycerin and a bit of wire. Batteries will also need replacing, but not for another few years. Personally I hate pointless waste. Throwing away something that’s usable is a sin in my eyes. If you won’t use it at least let somebody else use it instead, that includes the perfectly good components in disposables that get thrown away like trash.

Two that I know of that made decent games is K-D Lab that made Perimeter and Vangers (both open sourced and recently remastered), and Nikita responsible for the Parkan series. They’re not by any means greatest hits but they’re unique and worth checking out.

EDIT: And oh, Pathologic by Ice-Pick Lodge too, but I haven’t played those. Those seem funky and definitely not for everyone.

EDIT2: There’s apparently a list of Russian made games on Wikipedia , good to know.