Did you notice a difference in print speed when you slowed down? As this is a small print, it could already be as slow as it will be due to minimum layer times.
It could also be that the nozzle spends too much close to the print. What happens if you print 2 or 3 of them?
This is typically more of an issue with PC where you don’t have a part cooling fan running, but maybe it’s the case here too?
Definitely doesn’t sound like an issue with Tor Browser in Strict Mode. /s
The simple fact that buying a $300 device and to “not expect software updates” is not considered a scam is hilarious to me.
Interesting that the extra 10° makes such a difference for ASA and ABS.
I recently started printing with ASA in my enclosed MK4. I might have to try this.
Soit tout le monde a un vote, soit personne n’en a. Limiter la participation c’est créer des non-citoyens, et on a vu ce que ça donne.
Là où il faut intervenir c’est sur la participation. 51% à l’échelle européenne. 51.5% en France. La Belgique fait la fière avec ses 90% de participation, mais ça ne suffit pas. En Croatie 4 personnes sur cinq se sont abstenues. Bon nombre de pays où c’est 2 sur 3.
It could be a case of too much cooling, while simultaneously being too much heat.
If you’re blowing so much air that the filament instantly solidifies when it leaves the nozzle, it’s not going to bond with anything else. It’s also interesting that the first layers are fine (when the part cooling fan is typically not running), but problems start when the part cooling fan turns on.
Have you tried without part cooling at all? Another thing is that your part cooling might be cooling down the tip of the nozzle, causing tiny partial clogs, which are cleared every so often by friction.