petey@aussie.zone to 3DPrinting@lemmy.worldEnglish · edit-222 hours agoFriendly reminder to print awkward models on an angleaussie.zoneimagemessage-square13fedilinkarrow-up1125arrow-down10file-text
arrow-up1125arrow-down1imageFriendly reminder to print awkward models on an angleaussie.zonepetey@aussie.zone to 3DPrinting@lemmy.worldEnglish · edit-222 hours agomessage-square13fedilinkfile-text
This is a battery cell case that was a pain last time I printed it with supports Model: https://www.thingiverse.com/thing:5240533/files
minus-squareImgonnatrythis@sh.itjust.workslinkfedilinkEnglisharrow-up17·22 hours agoOhh nice, battery pez dispenser! Is that considered a raft + supports or just supports on there?
minus-squarepetey@aussie.zoneOPlinkfedilinkEnglisharrow-up8·21 hours agoJust supports, I had to manually paint them in to prevent the slicer from putting them all the way up the side
minus-squareTest_Tickles@lemmy.worldlinkfedilinkEnglisharrow-up5·7 hours agoIn Orca slicer, if you use tree supports and hybrid, an option appears (advanced must be enabled) for something like “Essential supports only”. It is so much better than spending all that time adding or blocking supports.
minus-squarepapalonian@lemmy.worldlinkfedilinkEnglisharrow-up2·21 hours agoLooks like the model is just resting on supports. Might have a roof or “support interface” (a layer between supports and model)
Ohh nice, battery pez dispenser!
Is that considered a raft + supports or just supports on there?
Just supports, I had to manually paint them in to prevent the slicer from putting them all the way up the side
In Orca slicer, if you use tree supports and hybrid, an option appears (advanced must be enabled) for something like “Essential supports only”. It is so much better than spending all that time adding or blocking supports.
Looks like the model is just resting on supports. Might have a roof or “support interface” (a layer between supports and model)